Monoprice Mini Select 3D V2 with Cura 4.2.1 Retraction Settings

Did a test print using Loohney's Basic Stringing Test, turned out pretty good. Print took about an hour.

Using the supplied profile for MP MIni Select 3D V2 in Cura 4.2.1, I customized only the retraction distance setting to 4mm. Here's a screenshot of the settings:

I used BamTack PLA, which tends to print best for me around 200C, bed temp 60C but with an initial setting of 65C for the first layer. The 65C will be set by the gcode when you load the print.

There were some very faint, wispy strings on the right column, which was acceptable - plus a spider-webby string (hard to see) when the hot end moved to its parking position. The left column was clean.